Hi,
We're using the Industrial Automation board version 3.2 with firmware 2.06. The 1-wire interface works great up until our temperatures go below 0°C. Below zero, we see readings jump around roughly between 50°C to 125°C. We've observed the same pattern with multiple boards and sensors, so I'm wondering if there might be a bug in the DS18B20 scratchpad conversion.
We tried the firmware update tool just in case this had already been fixed, but it seems like 2.06 is the most recent release.
Appreciate the help!
We're using the Industrial Automation board version 3.2 with firmware 2.06. The 1-wire interface works great up until our temperatures go below 0°C. Below zero, we see readings jump around roughly between 50°C to 125°C. We've observed the same pattern with multiple boards and sensors, so I'm wondering if there might be a bug in the DS18B20 scratchpad conversion.
We tried the firmware update tool just in case this had already been fixed, but it seems like 2.06 is the most recent release.
Appreciate the help!