Can Power LED of 16 input card be accessed

[JJJ]

Is there a way to access the LEDON signal (pin 34 PA12 [PA10] from python?

I have plenty of indicators of power but would like to repurpose that LED to an indicator of activity.

Thanks!

John

 

[alexburcea]

Could you please tell me the hardware version of your card?

 

[JJJ]

It is brand new. How do I tell the version?

Thanks!

 

[alexburcea]

Is printed on the card or better give me a picture of the top side of the card.

 

[JJJ]

It says V1.0 near the pushbutton.

Attached should be a picture. Oops, apparently the file is too large.

John

Thanks!

John

 

[alexburcea]

The V1.0 power LED is connected to +5V trough a resistor so the answer is you can not control it.
The schematics you look on our website is for V3.0 which was not produced yet.

Alex.

 

[JJJ]

Thank you for prompt, professional replies ! After I found the version number on the board, I went back and looked at the version 2 schematics and noticed that it only had 8 LED's and that the power LED was not connected to a controllable source.

Thanks again !

John