Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Home
Forums
Main category
Main forum
Open PLC and Industrial Automation card
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dstorey" data-source="post: 57" data-attributes="member: 23"><p>I did make the changes suggested and to no avail. I still see occasional misses. Either the led stays on or stays off for an extra cycle, like it misses the transition. I have also upped the I2C baud rate to 400Kbps to see if this made a difference, but I still see the drops. </p><p>I installed megaind and run it:</p><p>megaind 0 board</p><p>Firmware ver 02.02, CPU temperature 36 C, Power source 24.76 V, Raspberry 5.19 V</p></blockquote><p></p>
[QUOTE="dstorey, post: 57, member: 23"] I did make the changes suggested and to no avail. I still see occasional misses. Either the led stays on or stays off for an extra cycle, like it misses the transition. I have also upped the I2C baud rate to 400Kbps to see if this made a difference, but I still see the drops. I installed megaind and run it: megaind 0 board Firmware ver 02.02, CPU temperature 36 C, Power source 24.76 V, Raspberry 5.19 V [/QUOTE]
Verification
Post reply
Home
Forums
Main category
Main forum
Open PLC and Industrial Automation card
Top