Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Home
Forums
Main category
Main forum
Mosfet Hat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TonyD" data-source="post: 492" data-attributes="member: 37"><p>Giday</p><p>Help please</p><p>Could you please provide a little more info on running the command 8mosind as it doesn’t run from the command line.</p><p>Have commands 8mosfet & all the functions work from the command line</p><p>8mosfet 0 write 1 1</p><p>Turns on output 1 led lights</p><p>8mosfet 0 read 1</p><p>Returns a 1</p><p>The command 8mosfet read returns the correct information a 1</p><p>This is the same for all outputs</p><p></p><p>On a side not it would be nice if the commands across all cards were. ie the mosfet card doesn’t use -r as other cards use instead the hole word read is used</p><p>8mosfet 0 read 1</p><p>Other cards need 2 use -r</p><p>Also would be good if Leds on the mosfet card all went from left to right </p><p>12345678</p><p>Instead of</p><p>I think you may have a firmware problem</p><p>From command line</p><p>If I turn 1 on led 4 from the right turns on</p><p>If I turn l8 on 4 from left turns on as well as leds 6&7 from left turn on</p><p></p><p>I have not carried out any test rom python at this stage when I found the firmware problems </p><p>Please not I have not carried out all possible combinations after discovering the problem with output 8 I considered it a moot point</p><p></p><p></p><p>Regards TonyD</p></blockquote><p></p>
[QUOTE="TonyD, post: 492, member: 37"] Giday Help please Could you please provide a little more info on running the command 8mosind as it doesn’t run from the command line. Have commands 8mosfet & all the functions work from the command line 8mosfet 0 write 1 1 Turns on output 1 led lights 8mosfet 0 read 1 Returns a 1 The command 8mosfet read returns the correct information a 1 This is the same for all outputs On a side not it would be nice if the commands across all cards were. ie the mosfet card doesn’t use -r as other cards use instead the hole word read is used 8mosfet 0 read 1 Other cards need 2 use -r Also would be good if Leds on the mosfet card all went from left to right 12345678 Instead of I think you may have a firmware problem From command line If I turn 1 on led 4 from the right turns on If I turn l8 on 4 from left turns on as well as leds 6&7 from left turn on I have not carried out any test rom python at this stage when I found the firmware problems Please not I have not carried out all possible combinations after discovering the problem with output 8 I considered it a moot point Regards TonyD [/QUOTE]
Verification
Post reply
Home
Forums
Main category
Main forum
Mosfet Hat
Top