Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Home
Forums
Main category
Main forum
Issues with 4-20mA output
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="persjere" data-source="post: 591" data-attributes="member: 199"><p>Thanks for the response. I have version 3.2. Rewiring the outputs fixed the issue for two of my outputs. The third output, however, is putting out a reduced current value. The output ranges from approximately 3 to 11 mA when I set the output between 4 and 20 using the set4_20Out command. Additionally, output 4 puts out a fixed 65.0 mA when connected to a 250 ohm load. Do you think that wiring based on the outdated diagram damaged the board?</p></blockquote><p></p>
[QUOTE="persjere, post: 591, member: 199"] Thanks for the response. I have version 3.2. Rewiring the outputs fixed the issue for two of my outputs. The third output, however, is putting out a reduced current value. The output ranges from approximately 3 to 11 mA when I set the output between 4 and 20 using the set4_20Out command. Additionally, output 4 puts out a fixed 65.0 mA when connected to a 250 ohm load. Do you think that wiring based on the outdated diagram damaged the board? [/QUOTE]
Verification
Post reply
Home
Forums
Main category
Main forum
Issues with 4-20mA output
Top