Recent content by persjere

Thanks for the response. I tried three wiring configurations. The first was based on the outdated manual, with the DC voltage supply in series with the load. In the second configuration, I just added a fixed 250-ohm resistor across the fourth output to try the signal with a passive device. I...

Thanks for the response. I have version 3.2. Rewiring the outputs fixed the issue for two of my outputs. The third output, however, is putting out a reduced current value. The output ranges from approximately 3 to 11 mA when I set the output between 4 and 20 using the set4_20Out command...

I have the Industrial Automation Hat. I have successfully tested the mA inputs and discrete outputs but I can't seem to get the 4-20mA outputs to work. I followed the schematic from the manual (+DC to load, negative of load to +mA output on hat, -mA output on hat to -DC) and seem to be writing...