alexburcea's latest activity

Hi, You have the latest firmware (1.5). The calibration in progress status is wrong reported, there is no calibration in progress if...

Hi, It looks like the last firmware changes affect the one-wire bus functionality, give me some time to dig into it.

Try to connect the sensors before powering the card then do not initiate the scan procedure just read the count.

Hi, Do you use 2 wires or 3 wire sensors? We tested 3 wire sensors with success.

Hi, -The Eight MOSFET V3.1 is made with an I2C IOExpander, the switch time is limited by the I2C speed and by the fact that Raspberry...

Please set diferent stack level for relays and mosfets

Hi, A new firmware was released, and there was a problem with the DS18B20 data conversion but also with "megaind" command. Please...

Hi, Give us few days to dig into it and we will release a new firmware if is the case. Thank you for the bug report.

Usually, on a 3-wire RTD sensor, you have 2 of one color and one of a different color. On the card is drawn a resistor with 3 pins, 2...

The card is connected ? What is the stack level settings? It respond to the megaind command ?

If you put the script in cron or run it at few minutes interval from exec node, it will maintain the system time.

It might be an idea to install the library directly without the virtual environment. Open a terminal, browse to the 16relind-rpi/python/...

This is a possibility since the constant current circuit can not respond instantly, the output transistor might experience some high...

Hi Tony, I did not feel pushed, I tried to give you a solution before we will take care of the problem. Thank you for the complete...

Sorry for being slow, I am switching between projects and I had no Building Card installed to test with. I am glad you figured it out.